• Welcome to the new Distech Automation Forum!
  • Feel free to post questions, comments, and feedback.
  • Ask us anything!
Hello There, Guest! Login Register


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Large extrusion after tower end
#1
Hey,

So while testing the Filaswitch app with my new Printrbot Quad extruder set up, everything was ok until the hot end moves away from the tower to start a new layer and it produces a large extrusion, I found the following gcode line in the gcode file G1 E11.5000 F600, this happens 9 times in dual colour keychain model.

Any ideas how to stop this?

Thanks,

James.
Jay's 3D Adventure
Twitter:
twitter.com/Jays3DAdventure
Instagram:
instagram.com/jays_3d_adventure/
YouTube:
t.co/GesyvQVrZP
 
Reply
#2
Found it, it was the tool change retraction under the "other" tab is S3D. I had not changed this when I created my new profile.

Prometheus settings 2.5mm @80mm/s I believe, I'll give them a try.

J.
Jay's 3D Adventure
Twitter:
twitter.com/Jays3DAdventure
Instagram:
instagram.com/jays_3d_adventure/
YouTube:
t.co/GesyvQVrZP
 
Reply
  


Forum Jump:


Browsing: 1 Guest(s)