• Welcome to the new Distech Automation Forum!
  • Feel free to post questions, comments, and feedback.
  • Ask us anything!
Hello There, Guest! Login Register


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Always wanting more Extruders :-)
#1
Hey,

So whats the possibility of adding more extruders to the Prometheus System? Is a expansion board and 4 way splitter in the works?

Thanks,

James
Jay's 3D Adventure
Twitter:
twitter.com/Jays3DAdventure
Instagram:
instagram.com/jays_3d_adventure/
YouTube:
t.co/GesyvQVrZP
 
Reply
#2
(09-19-2017, 12:48 PM)3DPrintingReviews Wrote: Hey,

So whats the possibility of adding more extruders to the Prometheus System? Is a expansion board and 4 way splitter in the works?

Thanks,

James

I've discovered that the printrbot extrudrboard (for dual extrusion on the printrbots) can be connected to the RAMPS board, so 4 extruders should be easy to add, would just need the 4 to 1 splitter and @spegelius to add the option to the excellent software we are using  Wink.
Jay's 3D Adventure
Twitter:
twitter.com/Jays3DAdventure
Instagram:
instagram.com/jays_3d_adventure/
YouTube:
t.co/GesyvQVrZP
 
Reply
#3
Hey James,

The biggest obstacle that is holding us back is the fact that we would have to ensure compatibility with all standard controller boards. Additionally, slicers don't offer much support for 4 filament extrusion so the workflow is very tedious and not very user-friendly. It is just hard to make this 4 filament upgrade into a refined product. However, we are working on it!
 
Reply
#4
(09-20-2017, 12:44 AM)DisTech Automation Wrote: Hey James,

The biggest obstacle that is holding us back is the fact that we would have to ensure compatibility with all standard controller boards. Additionally, slicers don't offer much support for 4 filament extrusion so the workflow is very tedious and not very user-friendly. It is just hard to make this 4 filament upgrade into a refined product. However, we are working on it!

Yeah I can see from a new product point of view you need to make it compatible with everything currently supported, after more looking I see another board available for RAMPS which is just a pair of headers, some resistors and capacitors. Marlin would then just need the pins defining I think.

But yeah slicers also need to start supporting multi extruder prints and hardware. I love the solution spegelius came up with.

If you do/have made anything yet I'd love to help test it?

James.
Jay's 3D Adventure
Twitter:
twitter.com/Jays3DAdventure
Instagram:
instagram.com/jays_3d_adventure/
YouTube:
t.co/GesyvQVrZP
 
Reply
  


Forum Jump:


Browsing: 1 Guest(s)